General Product Information
The Green Yachting controller only uses full power when heating the water. The rest of the time it is only having to maintain the temperature and consumption is very limited. Because the water is heated to 52°, it is always being diluted with cold further reducing consumption. If the water is already warm when you start sailing, energy use will remain modest. Taking hot showers at night away from mains power will greatly increase battery power consumption and may need more battery capacity.
You need at least 300w of solar panels and 300A of AGM, gel, or lithium batteries. More capacity is fine. For lead acid, please contact us for advice.
The time taken to heat the water will vary according to the degree of heating required. In summer, allow an hour.
Enhanced 12/24v kit for for Quick boilersPrice€575.00
Enhanced 12/24v Isotherm boiler KitPrice€595.00
Enhanced 12/24v SOLAR GREEN ControllerPrice€295.00
Combined Switch & RemotePrice€195.00
12v/24v 300w Quick Water HeaterPrice€125.00
12v 300w Isotherm Water HeaterPrice€145.00
24v 300w Isotherm Water HeaterPrice€145.00
There are 2 versions of our system - Standard & Enhanced.
This page relates ONLY to the ENHANCED product.
The unit is the sameas that in the standard product. It has LEDs that are green telling you that it is correctly connected to the batteries but not heating the water, red when it is also heating the water. It is installed in the boiler compartment so that the supplied thermostat can check the water temperature, and it is cabled back to the domestic battery bank via a switch/fuse.
REMOTE MONITOR PANEL
The enhanced system also includes a remote monitor panel that has the same status lights as the main controller AND it acts as a Switch
/Fuse. the controller and the appropriate water heater element, but not the cabling, negative bus bar, or fuse/switch. All are available from most yacht chandlers. We supply kits for Quick and for Isotherm boilers.
All the heating elements are made to our specification and have specific provision for the thermostat supplied with the controller.
As standard, we only support boilers made by Quick and Isotherm. If your boiler is none of those, please contact us to discuss your installation. We will do our best to find a suitable solution.
Cables have to be run from the batteries to the controller in the boiler compartment, and from the controller to the heater.
Installation manuals are supplied for each specific configuration.
The device is controlling at least 25A from 300Ah batteries.
GREAT CARE NEEDED when installing.
I'm a paragraph. Click here to add your own text and edit me. It's easy.